国产一级毛片网站,国产精品成人影院,欧洲精品久久久

Content details

Overview of low-pressure heater (low-pressure heater):

The function of a low-pressure heater, abbreviated as a low-pressure heater, is to use the steam that has done some work in the turbine to extract it into the heater to heat the feedwater, increase the temperature of the water, reduce the amount of steam discharged from the turbine to the condenser, reduce energy loss, and improve the circulation rate of the thermal system. The conclusion is that a vertical tube plate heater is commonly used. The heating surface of the heater is generally composed of straight or U-shaped tube bundles made of brass pipes or slotted steel pipes.

Low pressure heater (low pressure heater) Figure 1

Low pressure heater (low pressure heater) - output potential:

Low pressure heater, low-pressure heater. The heated water enters the separated water chamber from the upper inlet pipe and then flows into the U-shaped pipe bundle. The U-shaped pipe absorbs the heat of the heated steam in the steam space of the heater, and is transferred to the flowing water inside the pipe by the pipe wall. The heated water flows out through the outlet water chamber of the heater.

Working principle of low-pressure heater (low-pressure heater):

The low-pressure heater (working principle of low-pressure heater) has both self flow and drainage pump circulation, and the difference in equipment is whether there is a drainage pump- A general power plant uses condensate water directly from the shaft seal heater to the low-pressure heater (different systems have different numbers, for example, 125MW and 300MW have 4-)

Low pressure heater, low pressure heater malfunction and measures:

1. The pipe bundle at the steam inlet is easily damaged by steam flow erosion. Low pressure heaters usually install a door protection baffle on the steam inlet pipe bundle to disperse steam flow and reduce its impact. 2. The heated water vaporizes in the heating water pipe of the heater, causing a water hammer. To prevent this phenomenon, it is required that the pressure of the heated water should be higher than the pressure of the heated vapor. 3. Non condensable gas accumulation. The air discharge pipe installed on the heater should be kept unobstructed.

Low pressure heater, low pressure heater structure - form:

Lianyungang Lingdong provides high and low pressure heaters (low-pressure heaters), which are vertical devices. The internal heating pipes are divided into two categories: disc-shaped pipes and U-shaped pipes, each with its own length, and can be selected according to user needs!

Low pressure heater, low pressure heater supply range:

1. Standardized production - and supporting production for the host factory-

2. Design and customize doors according to user requirements

3. Undertake maintenance such as replacing tube bundles and other equipment renovations, as well as technical renovation services

4. Provide high-pressure accessories such as heat exchangers and sealing rings

Low pressure heater, low pressure heater specifications technical parameters:

機組功率（MW）	管側設計壓力（MPa）	管側設計溫度（℃）	殼側設計壓力（MPa）	殼側設計溫度（℃）	給水流量（t/h）	每臺傳熱面積（㎡）	每種規格的臺數	低壓加熱器順序號	外形（mm）	-量（kg）
N6	1.0	100	0.6	150	34	20			Φ516×3500	780
N12		100		150	65	50			Φ616×4400	1366
-壓25		100		150	98	80	1	1	Φ720×4500	3200
-壓25		105		150	98	80	1	2	Φ720×4500	3200
50	1.5	100		150	171	100	2	1和2	Φ820×4600	3600
50		145		210	171	100	2	3和4	Φ820×4600	3600
75		100		150	239	160	2	1和2	Φ1020×4500	4950
75		145		210	239	160	2	3和4	Φ1020×4500	4950
100	1.8	100		150	311	200	2	1和2	Φ1232×4800	5320
100	1.8	145		210	311	200	2	3和4	Φ1232×4800	5320
125	2.2	150		150	350	260	1	1	Φ1132×6540	6100
		150		255	350	260	2	2和3
		150	0.64	325	350	260	1	1
200		100	0.6	150	510	340		1	Φ1332×6750	11500
200		115	0.6	210	510	340		2
200		130	0.6	270	510	340		3
200		150	0.7	350	510	340		4
300	3.5	100	0.6	150	737	600		1	Φ1426×9650	22400
		120	0.6	220	737	600		2
		150	0.6	270	737	600		3
		165	0.7	350	737	600		4
600	4	100	0.6	150	1426	1100		1	低加？	低加？
		120	0.6	220	1426	1280		2
		150	0.6	270	1426	1000		3
		165	0.7	350	1426	1250		4

以上低壓加熱器（低加）參數僅供參考，按實際設計為主！

你可能喜歡看：

Self regulating liquid level control device for gas-liquid two-phase flow

11-26

1025

The self regulating liquid level control device for gas-liquid two-phase flow is based on the principle of gas-liquid two-phase flow. The two-phase flow drainage controller is suitable for liquid level control of various heat exchangers and expanders in enterprises such as power, chemical, petroleum, and metallurgy. It is a replacement of the drainage regulator.

Blower silencer

11-25

1014

The blower muffler is mainly suitable for reducing the intake and exhaust noise of Roots series and axial flow series fans. The blower muffler can also be used for noise reduction of exhaust pipes and other high-pressure fans, with a noise reduction amount of 10-20dB (A) and a pressure loss of less than 500Pa.

Blow pipe silencer

08-20

975

Blow pipe silencers can be used to eliminate the noise generated by boilers and pipelines during blowing. Box type blow pipe silencers are divided into upper exhaust and partial exhaust, with the upper exhaust type being a box structure and the partial exhaust type being a circular structure.

Replacing the tube of the shaft seal heater

11-29

948

Manufacturer of shaft seal heaters, also undertaking pipe replacement and renovation of shaft seal heaters, replacing copper pipes, stainless steel pipes, boiler pipes, etc. According to customer needs, the replacement, repair, installation, and restoration of the relevant shaft seal heater pipes must be carried out. The original equipment must be sent to our company for pipe bundle replacement.

Steam seal heater tube replacement and renovation

11-29

883

The steam seal heater adopts a horizontal U-shaped surface heat exchanger for pipe replacement and transformation. The pipe material is stainless steel pipe, and in addition to expansion joint, the pipe also needs to be sealed and welded with the pipe plate; HSn-70-1 tin brass is also used and fixed on the tube plate by expanding the tube.

pressure type rotary membrane deaerator

11-27

827

The high working pressure of the pressure type rotary film deaerator is 0.59MPa or 0.78MPa (for subcritical units). The pressure of the low-pressure rotary film deaerator is greater than the ambient pressure (0.12MPa), and the temperature of the low-pressure rotary film deaerator is heated to 104 degrees with an oxygen content not exceeding 15ug/L. The temperature of the pressure type rotary film deaerator is around 160 degrees.

Blowdown cooler

11-27

781

A sewage cooler is an equipment that uses chemically treated water or raw water to cool sewage or other wastewater. Reduced heat loss while heating chemically treated water, increasing heat rate. It can also be used for cooling or heating water and steam media. There are two forms of sewage coolers: tubular sewage coolers and surface sewage coolers.

Continuous Blowdown Expander Continuous Blowdown Expander

11-27

777

Continuous blow down flash tank, also known as continuous blow down expansion tank, is connected to the continuous discharge outlet of the boiler and is used to reduce pressure and expand the capacity of the boiler.

Shaft seal heater

11-27

710

The shaft seal heater and shaft seal cooler are used to extract the steam and gas mixture from the steam seal system of the steam turbine, preventing steam from flowing from the end steam seal to the turbine room and oil system, polluting the environment and damaging the oil quality. These vapor compounds enter the shaft seal cooler and are cooled into water, etc.

High pressure rotary membrane deaerator

11-27

709

High pressure rotary film deaerator, also known as pressure rotary film deaerator, is the replacement of spray packing deaerator. It is a kind of thermal deaerator produced. The principle of rotary film deaerator is that make-up water is spirally sprayed through the film tube at a fixed angle to conduct heat exchange with heating steam for deoxygenation.